|Dealer Mobility Scooter||| Print ||
Dealer Mobility Scooter - Steps 1 > 7
Place the tyre valve so it is at either the 4 o’clock or 8 o’clock position, this will help the fluid enter the tyre or tube.
Use the special valve key provided to remove the valve from the tyre, be careful to keep it safe! The tyre will deflate.
Attach the Applicator Hose to the valve stem (a small chrome tab at the end of the brass tube needs to be depressed to allow it to lock onto the valve stem).
Ensure that the valve “lock” – indicated in the picture above – is moved from the “closed” position to the “open” position.
Make sure the pump is pulled out fully.
You are now ready to install the ShieldWell product. Almost all scooter tyres (all but the very large “off road” tyres) require 125ml of ShieldWell product.
The pump stem has engraved markings on it. One full stroke of the pump provides approximately 90ml of product. In order to install 125ml, you will need to pull the pump out fully, discharge it and then pull out the pump fully once more and then discharge it down to the first marking as indicated on the above picture. This will deliver a total of 125ml.
Two full strokes of the pump will deliver approximately 180ml of product which is sufficient for most of the larger tyres, if in doubt call us!
Ensure the valve “lock” is returned to the “closed” position as indicated in the picture above.
Remove the Applicator Hose.
Replace the valve with the tool provided.
Remove any spilled liquid with a little water.
Re-inflate the tyre to the correct pressure.
Clip the Applicator Hose back onto the valve on the front of the 20 litre container.
Open the valve “lock”
Push the pump down to the bottom to discharge the pump.
Close the valve “lock”
This will ensure that you are ready to correctly measure the next amount for the next tyre.
Repeat all the steps until all of the tyres are puncture protected.
When you have completed the installation, clip the Applicator Hose onto the valve on the front of the 20 litre container, open the valve “lock” and discharge any unused liquid into the container.
Close the valve “lock” and leave the Applicator Hose in this position to keep it out of the way. If you do decide to leave the Applicator Hose off of the container valve, then please ensure that the valve cover is put back onto the valve stem. (This will prevent product over exposure to the air).